Amadis

Interac Flash TA Session

Owned by Seyhmus Cacina (Unlicensed)
Last updated: Jun 06, 2020 by Olivier Chauvineau (Unlicensed)
1 min read

Entry Point Template

See Configuration page.

Transaction Related Data

Use the following tags (5F3601025F2A020124) in Other TLVs section:

  • 5F360102 Transaction Currency Exponent

  • 5F2A020124 Transaction Currency Code

See Transaction page.

Administrative Settings

  • Set ID Message Display = 1 in Administrative to clarify the identification of the message in the signals tab

  • For tests requiring the TVR, set Always Receipt = 1 in Administrative. Set Always Receipt = 0 for tests on record printing.

See TMS/Administrative dialog.

Test Case Execution

TA's configurations are driven by the tools that are used to qualify a kernel. For Interac Flash, ICC Solution is accredited. That tool doesn't define any configuration for each test case. Hence, the tester shall adapt the default configuration (CONF_01) depending on the test requirements.

Note:

  1. PROCESSING message display is mandatory to pass Interac Flash certification. It might had an time overhead depending on PoP capabilities. See GPI/SPED/display.c to add/skip that display

  2. If certifying framework 3.1.x, use kernel id = 0x08 for Interac Flash

  3. Terminal Country Code must be set to 0124 in TERMINAL configuration

See Test Cases Execution page.