...
The configuration file is typically located in /etc/amadis/atheosgw.conf.
Informational Messages
Atheos Gateway 02.01.05 started using configuration %s | |
Cause | AtheosGW startup message |
Action | None. |
Status | All versions. |
Atheos Gateway ended | |
Cause | AtheosGW processes are ended. The deamon is exiting. |
Action | None. |
Status | All versions. |
Closing the connection with %s, port %d | |
Cause | AtheosGW is closing the connection with the address %s, port %d. |
Action | None. |
Status | All versions. |
Connection closed by peer %s, port %d | |
Cause | The connection on from the address %s, port %d has been closed by the remove device. |
Action | None. |
Status | All versions. |
Copyright ©2005-2020 - 9164-4187 QUEBEC INC (“AMADIS”), All Rights Reserved | |
Cause | AtheosGW copyright during the startup process |
Action | None. |
Status | All versions. |
Error accepting the SSL connection with %s, port %d, code %d | |
Cause | The SSL connection could not be established with the device at address %s on port %d. The SSL status code is %d. |
Action | None. |
Status | All versions. |
Error reading the message header with %s, port %d | |
Cause | The header was not received from the remote device. Error messages are given above. |
Action | None. |
Status | All versions. |
Fatal error during the initialization of the Connection Manager. primaryError = %d | |
Cause | The initialization of the Connection Manager. Error messages are given above. |
Action | None. |
Status | All versions. |
Fatal error during the initialization of the file repositories. | |
Cause | The initialization of the file repositories. Error messages are given above. |
Action | None. |
Status | All versions. |
Log rotation completed | |
Cause | The rotation of the log file has been performed. |
Action | None. |
Status | All versions. |
Termination requested by the user | |
Cause | The termination signal (HUP signal) has been received. |
Action | None. |
Status | All versions. |
Warning Messages
%d connections are still active. | |
Cause | The termination signal has been received. Still %d connection are active. |
Action | None. |
Status | All versions. |
Terminating the connection with %s. | |
Cause | The connection was not closed timely during AtheosGW shutdown. |
Action | None. |
Status | All versions. |
Error Messages
accept() failed (%s) | |
Cause | AtheosGW could not accept (start reading and writing) an incoming connection. |
Action | Investigate the root cause of this error if it happens too often. The connection might have been closed prematurely. It can be a programming error in very rare occasions. %s might give a clue on the cause of this issue. If all POI connection generates this error message, try restarting AtheosGW. If it still fails, contact Amadis support. |
Status | All versions. |
...