...
Then for each configuration profiles using the Switch Profile button:
2. An EVAL popup appears indicating what are the configuration or settings to apply to the reader, as for example:
...
Then for each EVAL configuration part of the current Profile:
{
1.1 in ACE Client in the SETUP tab, adapt the tags to overload from the ACE Server configuration:
...
1.a Check the Use Default (Overload tags value with …)
...
CDA: Byte 2, bit 4
Overload tag 9F35 in ENTRYPOINT for these values (Offline Only/Online Only):
Merchant Controlled:
21 – Attended, Online only
22 – Attended, Online with offline capability
23 – Attended, Offline only
24 – Unattended, Online only
25 – Unattended, Online with offline capability
26 – Unattended, Offline only
...
2 in ACE Client in the CONFIGURATION/ENTRYPOINT once you have loaded the ACE Server Configuration:
1.b.2 Use tag DF1B in ENTRY POINT for these options:
Mobile CVM: Byte 5, bit 3
Terminal Exempt Of No CVM Checks: No CVM Check exempt: Byte 5, bit 2
...
Only EMV Mode: Byte and bit to define
1.b.3 Use tag DF30 in ENTRY POINT for these options:
...
Status Check: Byte 1 bit 8
1.b.3 4 Use tag 9F40 in ENTRY POINT for these options:
...
3 Send the ENTRY POINT configuration to the device
...
4 Execute the tests
...
5 Check if another configuration is expected in this Profile
} Next Config
...
. If there is one change the configuration and execute the test.
If end of all configs or per config, change the library to make the profile tests for both library.
...
If there is not any test left in that config change go back to step 4.1