...
Dual: Define parameters independent from the technology
Contact Only: Define L2 ICS parameters from the fields pertaining to this section
Contactless Only: Enable and define Contactless parameters
...
Fields
Field | Comment | Value |
---|---|---|
Dual | ||
Chip | Activate/Deactivate EMV Contact | 0 or 1 |
Swipe | Activate/Deactivate Magstripe Swipe | 0 or 1 |
PIN timeout | Define the PIN timeout in number of seconds. | 0 to 99 |
Contact | ||
Terminal Type | Define the Terminal type (tag 9F35) | 00 or |
Terminal Capabilities | Define the Terminal Capabilities (tag 9F33) | see 9F33 |
Additional Terminal Capabilities | Define the Additional Terminal Capabilities (tag 9F40) | see 9F40 |
Terminal Country Code | Define the Terminal Country Code (tag 9F1A) | see 9F1A |
Cardholder Confirmation | Activate/Deactivate Cardholder confirmation | 0 or 1 |
PSE | Activate/Deactivate PSE selection | 0 or 1 |
PIN Bypass | Activate/Deactivate PIN bypass | 0 or 1 |
RTS not suppported | Activate/Deactivate Random Transaction Selection | 0 if supported |
Velocity not suppported | Activate/Deactivate Velocity checking | 0 if supported |
CDA Type | Define the CDA Type | UNDEFINED or |
Default TAC | Activate/Deactivate default TACs | 0 or 1 |
TAC Denial | Default TAC denial value | same as TVR |
TAC Defaut | Default TAC default value | same as TVR |
TAC Online | Default TAC online value | same as TVR |
Online Data Capture | Activate/Deactivate Online Data Capture (ODC) | 0 or 1 |
Referral Managed | Activate/Deactivate Referral | 0 or 1 |
Advice Managed | Activate/Deactivate Advice | 0 or 1 |
Contactless Only | ||
EMV | C-1: n/a | 0 or 1 |
Autorun | Set PoP to auto run mode, i.e a preprocessing is performed right after transaction disposition to allow the system to resume with a start B and a polling (vending machine case) | 0 or 1 |
Predefined amount | If Autorun defined then Predefined amount is used as for 9F02, amount authorized | Any valid value below 10000 |
...
Important: load PROCESSING or define AID in PROCESSING first. The AID Ids in ENTRY_POINT depend on the AID order defined in PROCESSING.
Starting with version 3.2.28, AID Ids may be automatically modified if their values are above the number of AID in PROCESSING.
The following dialog lists automatic modifications:
...
C-2/MASTERCARD Data Storage tab
...